2
Contents
General Notes ............................................................................................................................. 2
Cleaning Procedures ................................................................................................................... 2
Seals and o-rings ........................................................................................................................ 2
Plastic or rubber components ...................................................................................................... 2
Metallic Components ................................................................................................................... 2
Tools ............................................................................................................................................ 3
Disassembly Procedure ................................................................................................................ 4
Reassembly Procedure ................................................................................................................. 6
Tuning and Final Testing ............................................................................................................. 9
General Notes
This regulator is designed for use with Enriched Gas (Nitrox) to EAN40. Use only perfectly
cleaned tools in a cleaned environment
Cleaning procedure
Please refer to the "SCUBAPRO CLEANING PROCEDURE" document
Seals and O-Rings
• All seals and o-rings shall be perfectly clean.
• Check o-ring lands for imperfections or burrs, and clean as needed.
• All o-rings, in particular those for dynamic use, must be lubricated, along with any adjacent
moving parts. The approved lubricant is Christolube MCG-111. Previous Technician
Seminars have indicated that Tribolube 71 is also acceptable, though this is not found in
official Scubapro publications.
• Note: The lubricant container, as well as tools and brushes used for service must be
perfectly clean, free from dust, hydrocarbons or other particulate matter.
Plastic or rubber components
• The components, particularly on sealing surfaces, should be free of deformation or damage.
• All threaded components should screw freely and without resistance, leaving no excessive
gap, unless otherwise specified.
Metallic components
• Metallic components should not have separated from the regulator or regulator part.
Chrome plating should be smooth without deformation, imperfections or damage.
To Next Page
Loading...
Need help?
General
