SCUBAPRO X650 SECOND STAGE
©2003 SCUBAPRO
Important note: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
11
Monoject
Install the o’ring on the fine adjustment
screw and the knob stem as shown.
NOTE: Do not lubricate the inner
thread or o’ring.
Thread the fine adjustment screw into
the knob stem. Turn counterclockwise
using the 3mm jeweler’s screwdriver
until the fine adjustment screw is flush
with the bottom of the knob stem.
Slide the external knob on the stem
and turn counterclockwise to “pull” the
mechanism into the knob assembly.
Monoject
Inspect and lubricate the sleeve o’ring.
Lightly lubricate the knob stem threads.
Thread the knob stem into the sleeve.
Use the adjustment knob to turn the
knob stem counterclockwise until it is
snug against the top of the sleeve.
To Next Page
Loading...
Need help?
General
