SCUBAPRO X650 SECOND STAGE
©2003 SCUBAPRO
Important note: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
13
P
/
N
4
3
0
4
0
0
0
0
TOOLS
NEEDED
No tools needed
this step
The stop clip groove should be now
visible when case is turned upside
down.
Install the stop clip. The “nipples” on
the stop clip should be aligned with the
round depression in the dive switch.
Use the X-650 tool to install the lever
as shown and engage the poppet.
NOTE: Apply pressure to the poppet to
determine if the poppet moves freely
and is installed properly.
This step performed only as needed
If the case plug was removed, inspect
and lubricate the top case plug o’ring.
Install as shown.
Lubricate the first two or three threads
of the screws and thread into the case
and plug.
CAUTION: Do not over-tighten screws.
To Next Page
Loading...
Need help?
General
