5.6 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the below steps to
manually tare off the weight of container and get the
net weight.
a. Remove all loads away from platter
b. Make sure that the ZERO INDICATOR is on.
c. Place the container on the platter.
d. Press TARE.
After TARE is pressed, the NET INDICATOR would appear.
Refer to 5.2 for weighing procedures. Weight displayed
under is the net weight of the subject matter. Refer
to SPECIFICATIONS for maximum tare range.
NOTE:
- When scale is set at OIML and application is legal
for trade. User only needs to press TARE once when tare
off a weight. The tare function will take place when
reading is stabled
- When scale is set at Non-OIML and application is not
legal for trade. User can tare off the weight anytime
when pressing TARE
To Next Page
Loading...