UWE ADW-E Series - Clear Tare Function; Weight Check Function

5.7 CLEAR THE TARE FUNCTION
a. Remove all loads from platter
b. The tare effect will be cancelled:
-Automatically if automatic tare function is
employed, or
-By pressing TARE
c. After TARE is pressed, the NET INDICATOR would
disappear.
5.8 WEIGHT CHECK FUNCTION
This scale is equipped with Weight Check Function. An
audio and video signal is generated to reflect the weight
check result.
5.8.1 Setting the High, Low Weight Limits and Buzzer
Warning
a. Remove all loads from platter
b. Turn scale on
c. Make sure that ZERO INDICATOR is on; if not, press
ON/ZERO
d. Press and hold ON/ZERO, then press TARE
e. The HI INDICATOR appears and the cursor is flashing,
scale is now in upper weight limit setup
f. Utilize MODE, TARE and ON/ZERO to set the required
high weight limit