10 Versacount II+ User’s Guide
Operating Instructions 61673621.fm
Operating Instructions
The Versacount II+ can be used in a number of configurations depending on the options that
have been purchased with the counter. This section will cover three basic configurations and out-
line the general procedure the operating the Versacount II+ counter for each.
The standard configuration of the Versacount II+ is counting taped SMD component reels without
an empty pocket detector. Instructions for this configuration are found under the heading Count-
ing SMD Reels without an EPD below.
If an empty pocket detector module option is installed on the machine, then follow the instruc-
tions under Counting SMD Reels with an EPD.
If the Axial/radial kit option was purchased with the Versacount II+, follow the instructions for its
use under Counting Leaded Reels.
To Next Page
Loading...