Safety Precautions 61673513.fm iv
Safety Precautions
General Precautions
Only qualified personnel with the proper technical training, experience working on this type of
equipment, and awareness of the possible hazards should perform maintenance on the Ver-
sacount II+.
The Versacount II+ should be installed on a level and stable surface before any operation or
maintenance is performed.
This manual should be read and thoroughly understood before operating the machine.The guide-
lines provided in the following pages are intended to educate the user about how to operate the
Versacount II+ safely. They contain important information on avoiding potential hazards to the
operator and to the equipment.
Safety Precautions
Observe the following safety precautions when working with the Versacount II+.
Maintenance
Always disconnect the power source from the machine before removing access
panels to perform any maintenance required. Please refer to Chapter 2 of this
manual before performing maintenance on the machine.
AC Receptacle
Connect the power cord to the machine before plugging it into an outlet.
Contact Information
V-TEK, Inc.
751 Summit Ave
Mankato, MN 56001
TEL: (507) 389-2039
website: http://www.vtekusa.com
For customer service, please refer to the Customer Service Contact Sheet at the back of this
manual.
To Next Page
Loading...