26 Versacount II+ User’s Guide
Counting Leaded Reels 61673621.fm
The counter will continue counting pockets while in the stopped condition. The operator can turn
the reels manually to reach an exact count, if desired. Alternatively, pressing STOP/GO will
cause the counter to resume transfering the reel, if the counter was stopped before reaching the
STOP count.
The Stopped Screen also displays the direction arrow and the current count. When this screen is
displayed, the operator can change the counting direction by pressing the left or right arrow key.
If the reel count is complete, the operator can choose to press 5 on the keypad to send the parts
and empty pocket count data to an hardware option if one is installed and enabled. Otherwise,
pressing the ESC key will clear the current counts and return to the Setup Screen.
The “5=” message will appear if a hardware option is installed and enabled and will depend on
the hardware option that is installed. In Figure 1-41, the label printer option is enabled. If the PC
option is enabled, the message will read 5=SEND TO PC.
To Next Page
Loading...