V2 BY Series - User Manual

I
L n. 348-1
E
DIZ. 09/05/2011
BY
V2 S.p.A.
Corso Principi di Piemonte, 65/67 - 12035 RACCONIGI (CN) ITALY
tel. +39 01 72 81 24 11 fax +39 01 72 84 050
info@v2home.com www.v2home.com
AUTOMAZIONE PER
BARRIERE STRADALI
AUTOMATION FOR STREET
BARRIERS
AUTOMATISME POUR
BARRIERES ROUTIERES
AUTOMATIZACIÓN PARA
BARRERAS VIALES
AUTOMATIZAÇÃO PARA
BARREIRAS AUTOMÁTICAS
I
GB
F
E
P

Summary

IMPORTANT REMARKS

TECHNICAL CHARACTERISTICS

PREPARATION FOR AUTOMATION OF THE BASE

BOOM INSTALLATION

For the flat boom follow the following indications

For the round boom follow the following indications

INSTALLATION OF THE BALANCE SPRING

BALANCING OF THE BOOM

CONTROL UNIT INSTALLATION

POWER SUPPLY

Electrical connection requirements and protection.

PHOTOCELLS

Installation and connection of photocells for safety.

SAFETY RIBBONS

ACTIVATION INPUTS

STOP

TABLE OF ELECTRICAL CONNECTIONS

SYNCHRONIZED OPERATION OF TWO BARRIERS

CONTROL PANEL

USE OF THE DOWN, MENU AND UP KEYS FOR PROGRAMMING

QUICK CONFIGURATION

LOADING OF DEFAULT PARAMETERS

Restoring all parameters to their default values.

AUTO-LEARNING END-STOP

Automatic learning of barrier opening and closing end-stops.

OPERATION OF THE OBSTACLE DETECTION SENSORS

CONTROL UNIT CONFIGURATION

Menu Navigation

Overview of Function, Time, and Value menus.

Energy Saving and Gripper Settings

Direction and Obstacle Sensor Settings

Setting direction, obstacle detection, and slowdown parameters.

Command and Timing Settings

Configuring start commands, automatic closing, and pause times.

Input and Output Settings

Input Behavior Settings

Safety Tests and Programming Completion

READING OF CYCLE COUNTER

OPERATION DEFECTS

INSTALLATION OF ACCESSORIES

Sensiva Photocell; Blinko Flashing Light

V2 BY Series Specifications