V2 EASY-BASIC User Manual

FRANÇAIS
- 15 -
PROG
F2
F1
WORK
Rx
PAUSE
H1 H2 H3 H4 H5 H6 H7 H8 E1 E2 E3 E4 E5 N L
START STOP PHOTO
J1
1 2 3 4 5 6
START
PHOTO
STOP / EDGE
COM
24 VAC-3W
COM
LAMP
OPEN
COM
CLOSE
NEUTRAL
PHASE
Max.40W
ANT
m IMPORTANT: Les entrées normalement fermées STOP/
EDGE (H4) et PHOTO (H6) si elles ne sont pas utilisées
doivent être raccordées par pontage au câble COMMUN
(H5)

V2 EASY-BASIC Specifications

General

Input Voltage	24 VDC
Output Voltage	24 VDC
Storage Temperature	-20°C to +70°C
Weight	200g
Protection Class	IP20
Humidity	non-condensing

Summary

Important Remarks and Safety

Manual Reading and Programming Guidance

Read manual carefully before installation and programming.

Compliance with European Regulations

Implement automation according to current European regulations.

EU Declaration of Conformity

Product Disposal and Recycling

Proper disposal procedures for the product.

Control Unit Description

Electrical Connections Overview

Details of electrical connections for terminals H1-H8 and E1-L.

Technical Specifications

Cable Gland Assembly Instructions

Work Time Adjustments

Control Unit LED Indicators

Programming Operational Logic

Lighting Functions Setup

Settings for courtesy and flashing light outputs.

Operation Mode Configuration

Configuration of automatic and step operation cycles.

Start Logic Settings

Control of start command during opening.

Dead Man Logic Configuration

Operation logic requiring continuous press or standard start.

Photocell Function Settings

Photocell intervention during opening and closing.

Pre-Flashing Settings

Activation of flashing light before motor start.

Emergency Dead Man Operation

Remote Radio Learning Procedure

Rolling Code Mode Settings

Storing Transmitters

Full Code Erasing Procedure