V2 GOLD400D Series - Page 48

ENGLISH
46
Pd8 FUNCTION TABLE
DISPLAY DATA DESCRIPTION DEFAULT
MEMO
DATA
t.AP 0.0" ÷ 2.0' Gate opening time 15.0"
t.APP 0.0" ÷ t.AP1 Opening time of pedestrian gate 6.0"
t
.Ch
0
.0" ÷ 2.0'
G
ate closing time
1
6.0"
t
.ChP
0
.0" ÷ t.Ch
C
losing time of pedestrian gate
7
.0"
t
.PrE
0
.5" ÷ 2.0'
P
re-flashing time
1
.0"
no - Pre-flashing disabled (it corresponds to 0)
dir Gate direction (the direction you see from the inside) dx
dx - The gate opens rightwards
Sx - The gate opens leftwards
Pot 30 ÷ 100% Motor power 85
SPUn no/Si Start off no
t.P.So 0.5" ÷ 3.0" Slowed down starting time 1.5"
no - Slowed down starting disabled
t.raL 0.5" ÷ t.AP Slow down time 2.0"
no - Slow down disabled
St.AP Start in opening PAUS
no - Start command is not available
ChiU - Command close gate
PAUS - Stop the gate and goes in pause
St.Ch Start in closing StoP
Stop - Start command stop the gate
APEr - Start command open the gate
St.PA Start in pause ChiU
no - Start command is not available
ChiU - Start command closes the gate
SPAP Pedestrian in opening PAUS
no - Pedestrian start command is not available
ChiU - Pedestrian start command closes the gate
PAUS - Gate goes in pause
Ch.AU Automatic closing no
no - The gate closes after the setup time)
0.5"÷ 20.0' - The automatic closing is not active (it corresponds to 0)
Ch.tr Closing after passage no
no - Closing after passage disabled
0.5"÷ 20.0' - Gate stop for a time to be set between 0.5" to 20'
LP.PA no/Si Flashlight in pause no
PA.tr no/Si Pause after transit no