V2 STARK6 - Page 9

ENGLISH
- 17 -
Before it can be fixed to the wall, the bracket must be welded to
the fastening plate (Fig. 3); the bracket may be cut to the desired
length, adjusting distances A and E accordingly
NOTE - The bracket supplied with the gearmotor is 180 mm
long
m WARNING! Before fixing the rear bracket, make sure
that the front bracket will be fixed to a solid position of
the gate leaf; the front bracket will have to be secured at a
different height than the rear bracket (Fig. 4).
28 mm
Fix the bracket in place using suitable plugs, screws and washers
(not supplied)
INSTALLATION OF THE FRONT FIXING
BRACKET
1. For the installation of the front bracket to the gate leaf, refer
to distance D (fig. 2).
2. Define the front bracket installation height in accordance with
fig. 4.
3. Fix the bracket to the solid section of the gate leaf.
FIG.3
FIG.4
g
W [mm] E [mm] A [mm]
90°
20 200
if S > 20
A = 80 + (S - 20)
if S < 0
A = 80
30 210
40 220
50 230
60 240
70 250
80 260
90 270
100 280
110 290
120 300
130 310
140 320
150 330
160 340
170 350
180 360
190 370
200 380
g
W [mm] E [mm] A [mm]
100°
20 200
A = 120 + S
30 210
40 220
50 230
60 240
70 250
80 260
90 270
100 280
110 290
120 300
130 310
g
W [mm] E [mm] A [mm]
110°
20 200
A = 155 + S
30 210
40 220
50 230
60 240