11
BLOWER OPERATION
This ash vacuum has blowing capabilities.
To use the blower feature follow the instructions listed.
1. Insert the large end of the hose into the blower connection in the top of the motor housing (Fig. 1).
2. Ensure the on/off switch is turned to the "O" (OFF) position, then plug the power cord into the
electrical outlet (Fig. 2).
3. Turn the motor on by ipping the switch to the "I" (ON) position (Fig. 3).
4. The unit will now blow through the vacuum hose. This can be used to clear obstructions in the
hose, or to convert the vacuum to a blower (Fig. 4).
WARNING:
ALWAYS WEAR SAFETY GOGGLES BEFORE USING BLOWER.
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS. WEAR A DUST MASK IF
BLOWING CREATES DUST THAT MIGHT BE INHALED.
1
2
3
4
O
I
To Next Page