Vacmaster VK1323PFR - Page 14

14
GB
proportion of water: 25ml of detergent solution mixed with 1 litre of warm water. When the supplied
detergent sample is empty, buy a low foam detergent and refer to the applicable carpet solutions
‘directions for use’ (Fig. 20).
CAUTION:
THE DETERGENT SOLUTION CAN CAUSE SERIOUS SKIN AND EYE
IRRITATION. WASH AFFECTED AREA CAUTIOUSLY WITH WATER FOR SEVERAL
MINUTES. IF IRRITATION PERSISTS, SEEK MEDICAL ATTENTION IMMEDIATELY.
INDIVIDUALS WITH SENSITIVE SKIN SHOULD WEAR RUBBER GLOVES. WASH
HANDS THOROUGHLY AFTER USE. DO NOT INGEST. KEEP OUT OF REACH OF
CHILDREN.
WARNING!
DO NOT RUN THE PUMP WHEN THERE IS NO DETERGENT IN THE
DETERGENT TANK.
WARNING!
ALWAYS USE A LOW FOAM DETERGENT OR USE A DE-FOAMING
AGENT.
4) Close the detergent tank cap. Replace the detergent tank into the vacuum. Ensure the
detergent tank connecting hose is locked securely into the inlet coupling.
5) Secure the locking end of the suction hose into the vacuum suction port. Connect the end of
the detergent delivery tube onto the outlet coupling on the front of the power head.
6) Push the end of the remote control handle into the extension wand, make sure that the
coupling (
②
) on the remote control clicks into the detergentinlet connector (
③
) on the
extension wand (Fig. 21 & 22).
7) Attach the carpet lance to the extension wand and make sure it clicks into place (Fig. 23 & 24).
For best performance, it is recommended to remove the brush holder during carpet cleaning.
To remove the brush holder, slide this to the right as indicated by the arrow and then move
down (Fig. 25).
To re-install the brush holder, make sure to rst align the arrows on the brush holder and the
carpet lance as shown. Then move the brush holder to the left as indicated by the arrow until
you hear a "click" (Fig. 26).
CAUTION:
NEVER PRY OR ROTATE THE SPRAY OUTLETS OF THE CARPET
LANCE AND HANDHELD LANCE WITH A SCREWDRIVER OR ANY OTHER TOOL (Fig.
27 & 28).
8) To clean fabrics and upholstery, connect the handheld lance onto the remote control handle
(Fig. 29).
NOTE: Adjust the air ow regulation to decrease the suction power if the suction power is high. If
there is dirt or debris accumulated in the handheld lance, press the release button and remove the
cover from the lance for cleaning (Fig. 30).
9) Plug the power cord into a power outlet.