Vacon Plc Phone: +358-201 2121 Fax:+358-201 212 205
Service: +358-40-8371 150 E-mail: vacon@vacon.com
E-mail: application.team@vacon.com
Vacon Page 5
Pump control with autochange
Number Parameter Range Step Default Customer Description
0. 1 Application 0— 7 1 0 0 = Pump and fan control with auto-
selection change (loaded special application)
1 = Basic Application
2 = Standard Application
3 = Local / Remote Control Application
4 = Multi-step Speed Application
5 = PI-control Application
6 = Multi-purpose Control Application
7 = Pump and fan control Application
0. 2 Parameter 0— 5 1 0 0 = Loading ready / Select loading
loading 1 = Load default setting
2 = Read up parameters to user's set
3 = Load down user's set parameters
4 = Read parameters up to the panel
(possible only with graphical panel)
5 = Load down parameters from panel
(possible only with graphical panel)
0.3 Language selection 0—1 1 0 0 = English
1 = Finnish
2= Spanish
4 Parameter group 0
0.1 Application selection
With this parameter the active application can be selected. If the device has been ordered
from the factory equipped with pump and fan control with autochange application this has
been loaded to the unit as application 0. The application has also been set active in the fac-
tory. Check anyway that the value of the parameter 0.1 is zero when you want to use the
pump and fan control with autochange application.
If the application is loaded to the device later it has to be set active always after loading
by setting the value of parameter 0.1 to zero.
0.2 Parameter loading
See User's manual chapter 11.
0.3 Language
With this parameter the language of the graphical panel can be selected.
To Next Page
Loading...
Need help?
General
