Need help?Do you have a question about the Vacon NXP and is the answer not in the manual?
General| Brand | Vacon |
|---|---|
| Model | NXP |
| Category | Media Converter |
| Language | English |
Explains connecting inputs/outputs to functions via the control keypad.
Describes mapping functions to terminals using NCDrive software.
Details configuring unused input and output terminals.
Lists M1 monitoring values showing actual signals and statuses.
Details basic parameters for motor config & drive settings (M2→G2.1).
Covers analogue and digital input signal config (M2→G2.2).
Details parameters for configuring digital and analogue output signals.
Defines parameters for output frequency & torque limit supervision.
Parameters for enabling and controlling the mechanical brake.
Parameters for ramp shapes, accel/decel, and start/stop functions.
Settings for motor control modes, U/f curves, and speed controllers.
Parameters for motor thermal, stall, and phase supervision protections.
Configures fieldbus data output and synchronization control.
Parameters for setting torque limits and reference selection.
Master/follower settings, sync acceleration, and phasing parameters.
Info on software license keys and trial time.
Parameters for controlling the drive via the keypad interface.
Access to general settings like application and language selection.
Info on attached expander and option boards.
Covers max frequency, accel/decel times, and current limit parameters.
Details linear, squared, and programmable U/f curve characteristics.
Parameters for selecting and configuring analogue inputs (Al1, Al2).
Explains start/stop logic, direction control, and basic motion functions.
Parameters for frequency limit supervision and detecting various faults.
Parameters for enabling synchronization, setting modes, and phasing.
Detailed parameters for enabling and controlling the mechanical brake.
Illustrates functional blocks of the shaft synchronization control.
Diagram showing gear ratio control during operation.
Timing diagrams for sync commands, speed, and outputs.
Visual representation of sync control states and transitions.
Info on closed loop control modes and parameters.
Specific notes for using permanent magnet motors in closed loop.
To Next Page
