shaft synchronization application – parameter lists vacon • 31
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
6
6.11 License key (Control keypad: Menu M2 G2.10)
Code Parameter Min Max Unit Default Cust ID Note
P2.10.1 License key 0 65535 0
1694
Software enable code
related to the serial
number of power unit
V2.10.2
Power unit serial
number key
0 65535 0
1515
Serial number key of the
power unit. Value for
monitoring only.
Table 24. License key parameters
6.12 Keypad control (Control keypad: Menu M3)
The parameters for the selection of control place and direction on the keypad are listed below. See
the Keypad control menu in the product's User's Manual.
Code Parameter Min Max Unit Default Cust ID Note
P3.1 Control place 1 3 1 125
1=I/O terminal
2=Keypad
3=Fieldbus
R3.2 Keypad reference Par. 2.1.1 Par. 2.1.2 Hz
P3.3
Direction (on
keypad)
0 1 0 123
0=Forward
1=Reverse
P3.4 Stop button 0 1 114
0=Limited function of Stop
button
1=Stop button always
enabled
R3.5 Torque reference 0,0 100,0 % 0,0
Table 25. Keypad control parameters, M3
6.12.1 System menu (Control keypad: Menu M6)
For parameters and functions related to the general use of the frequency converter, such as
application and language selection, customised parameter sets or information about the hardware
and software, see the product's User's Manual.
6.12.2 Expander boards (Control keypad: Menu M7)
The M7 menu shows the expander and option boards attached to the control board and board-
related information. For more information, see the product's User's Manual.
To Next Page
Loading...
Need help?
General
