description of parameters vacon • 77
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
1515 Power unit serial number key
(V2.10.2)
Monitoring value for power unit serial number key
This application software (the shaft synchronization mode) is protected by an individual
license key tied to the power unit serial number of the drive on which it is installed.
The unit will work in the multi-purpose mode only, until the right license key has been
set by parameter P2.10.1. (Possible to run in Shaft Synchronization mode 2 weeks
without license key during Trial Time)
Please request the appropriate key of your Vacon representative according to your
license agreement. The data you shall specify to obtain your key are
− the frequency converter serial number and, in case the unit is restarted after
replacing power unit or power card
− the value of this parameter
PowerUnitSerNoKey
that you can read after ID1694 in the
same submenu.
Enter the key in P2.10.1 and the unit will then be ready for use in shaft synchronization
mode. After setting the right key, P2.10.1 will automatically lock to prevent accidental
corruption of the value. When downloading a set of parameters using the NCDrive PC
tool, a write error on this parameter may occur. This is normal and will not affect the
operation of the downloaded parameter set.
To Next Page
Loading...
Need help?
General
