description of parameters vacon • 85
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
7.1 Keypad control parameters
Unlike the parameters listed above, these parameters are located in the M3 menu of the control
keypad. The reference parameters do not have an ID number.
114 Stop button activated
(3.4, 3.6)
If you wish to make the Stop button a "hotspot" which always stops the drive regardless
of the selected control place, give this parameter the value 1.
See also parameter ID125.
125 Control Place
(3.1)
The active control place can be changed with this parameter. For more information, see
the product's User's Manual.
Pushing the
Start button
for 3 seconds selects the control keypad as the active control
place and copies the Run status information (Run/Stop, direction and reference).
123 Keypad Direction
(3.3)
0 Forward: The rotation of the motor is forward, when the keypad is the active
control place.
1 Reverse: The rotation of the motor is reversed, when the keypad is the active
control place.
For more information, see the product's User's Manual.
R3.2 Keypad Reference
(3.2)
The frequency reference can be adjusted from the keypad with this parameter.
The output frequency can be copied as the keypad reference by pushing the
Stop button
for 3 seconds when you are on any of the pages of menu
M3.
For more information, see
the product's User's Manual.
R3.5 Torque reference 6
(3.5)
Define here the torque reference within 0.0…100.0%.
To Next Page
Loading...
Need help?
General
