Vacon OPT-A2 - 3 Brake Chopper Application - Parameter Lists; Monitoring Values (Control Keypad: Menu M1)

Brake Chopper Application – Parameter lists vacon • 7
24-hour support +358 (0)40 8371 150 • Email: vacon@vacon.com
3. BRAKE CHOPPER APPLICATION – PARAMETER LISTS
On the next pages you will find the lists of parameters within the respective parameter groups.
Column explanations:
Code = Location indication on the keypad; Shows the operator the present parameter
number
Parameter = Name of parameter
Default = Value preset by factory
Min = Minimum value of parameter
Max = Maximum value of parameter
Unit = Unit of parameter value; given if available
ID = ID number of the parameter (used with PC tools and fieldbus)
Note = Description of parameter
3.1 Monitoring values (Control keypad: menu M1)
The monitoring values are the actual values of parameters and signals as well as statuses and
measurements. Monitoring values cannot be edited.
See Vacon NX User's Manual, Chapter 7 for more information.
Code Parameter Unit ID Note
V1.1 Total Current A 1104 Filtered braking current in Amperes.
V1.2 Power kW 1106 Braking power in kW.
V1.3 DC-link Voltage V 1108 DC intermediate voltage in Volts
V1.4 Unit Temperature °C 1109 Unit temperature C-degrees.
V1.5 ANALOG OUTPUT 1 % 1112 Analog Output 1 in%
V1.6 DIN1, DIN2, DIN3 15 Digital Inputs A1, A2 and A3 Status (sum)
V1.7 DIN4, DIN5, DIN6 16 Digital Inputs B4, B5 and B6 Status (sum)
V1.8 DO1, RO1, RO2 17 Digital Output and Relay 1&2 Status (sum)
V1.9 Unit Nom Voltage V 111 Nominal voltage rating of the Frequency
Converter.
V1.10 Unit Nom Current A 1118 Nominal current rating of Frequency Converter.
V1.11 DC Nom Voltage V 1120 Nominal value of Dc-link voltage in Volts.
V1.12 MainControlWord 1160 See the chapter 5
V1.13 MainStatusWord 1162 See the chapter 5
V1.14 Active Fault 37 Active fault code
V1.15 PT100(1) Temperature °C 50 Temperature measured with PT100 sensor 1
V1.16 PT100(2) Temperature °C 51 Temperature measured with PT100 sensor 2
(only when OPT-B8 is used)
V1.17 PT100(3) Temperature °C 52 Temperature measured with PT100 sensor 3
(only when OPT-B8 is used)
Table 3-1. Monitoring values