Vacon OPT-A2 - BCU in Parallel; Fieldbus Parameters

Description of parameters vacon • 17
24-hour support +358 (0)40 8371 150 • Email: vacon@vacon.com
4.4 BCU In Parallel
2.4.1 Drooping (ID1501)
Increase in braking current will increase the DC link voltage level for operation as a
function of drooping. This parameter is applicable only when there is more than one BCU
connected in parallel.
4.5 Fieldbus parameters
2.5.1 –
2.5.8 Fieldbus data out 1-8 selection (ID1490-ID1497)
Using these parameters, you can monitor any monitoring or parameter value from the
fieldbus. Enter the ID number of the item you wish to monitor for the value of these
parameters.
2.5.9 –
2.5.16 Fieldbus data in 1-8 selection (ID876-ID883)
Using these parameters, you can control any parameter value from the fieldbus. Enter
the ID number of the item you wish to control for the value of these parameters.