vacuubrand MZ 2C NT+2AK User Manual (English)

Questions and Answers:

M
Margaret BeardAug 11, 2025
What to do if my vacuubrand MZ 2C NT+2AK doesn't start?
- S
  Stephanie SparksAug 11, 2025
  If your vacuubrand Water Pump doesn't start, it could be due to several reasons. First, ensure the electrical power cord is properly plugged in. Also, check the device fuse to see if it has blown. Overpressure in the outlet line or a motor overload could also be the cause. If the motor is overloaded, allow it to cool down, identify, and eliminate the cause of the failure. A manual reset might be necessary, so switch off the pump or unplug it.
H
herreraashleyAug 27, 2025
How to fix a noisy vacuubrand MZ 2C NT+2AK?
- F
  fadamsAug 27, 2025
  A noisy vacuubrand Water Pump can be caused by atmospheric or high pressure at the pump inlet. Try connecting a hose or silencer to the pump outlet, being careful not to cause outlet over-pressure, especially with condensable vapors. Another cause could be a diaphragm crack or a loose diaphragm clamping disc, in that case perform maintenance. If the cause is something else, contact your local distributor.
C
Cody DrakeSep 2, 2025
What to do if vacuubrand Water Pump does not start?
- A
  Alicia StokesSep 2, 2025
  If your vacuubrand Water Pump fails to start or stops immediately, it could be due to several reasons: * The electrical power cord might not be plugged in. * There could be an electrical supply failure. * The device fuse might be blown. * There might be overpressure in the outlet line. * The motor could be overloaded. Here are some steps to take: 1. Ensure the power cord is properly plugged in. 2. Check the fuse and replace it if necessary. 3. Identify and address the cause of the failure. 4. Remove any blockage in the line and open the valve. 5. Allow the motor to cool down, then identify and eliminate the cause of the overload. A manual reset may be necessary. Switch off or unplug the pump.

vacuubrand MZ 2C NT+2AK Specifications

General

Number of Stages	2
Ultimate Vacuum	7 mbar
Free Air Capacity	2.0 m³/h
Motor Power	0.18 kW
Max. pumping speed	2.0 m³/h
Inlet connection	Hose nozzle DN 10 mm
Outlet connection	Hose nozzle DN 10 mm
Permissible ambient temperature	10-40 °C