Page 1 of 7
& UPDATE INSTRUCTIONS
RoboSHOT 12 and 30 HDBT Cameras
Current Release
RoboSHOT® 12/30 HDBT 3.1.0
May 13, 2019
Improvements
• In the admin web interface, various camera behavior settings have moved from soft DIP switches to the
General tab of the System page.
• Some parameters were incorrectly stored in CCU scenes and in presets stored with color information.
This has been fixed.
• Executing several pan, tilt, or zoom to absolute position commands in quick succession could generate
error messages. This has been fixed.
• When changing camera settings from a connected device, in some cases the camera's web interface did
not immediately reflect the change. This has been fixed.
• In some cases, the web interface did not load properly if the computer had recently accessed another
Vaddio device at the same IP address. This has been fixed.
Release History
RoboSHOT 12/30 HDBT 3.0.1
February 15, 2019
New Features
• Added support for RTMP streaming. This is configured in the admin web interface and can be
enabled/disabled in both the admin and the user web interface.
Improvements
• Improved handling of HDMI hot-plug events.
• Improved camera behavior during lengthy camera operations.
• Improved camera behavior when an operator rapidly and repeatedly cancels and restarts camera
operations.
RoboSHOT 12/30 HDBT 1.3.0
November 16, 2018
New Features
• Support for UVC proxying from a OneLINK Bridge to enable far-end control when used with some third-
party soft codec clients like Zoom that support UVC standards.
• One Push White Balance can now be executed through the web interface.
• HTTPS access to the camera is now supported and the HTTPS certificate can now be configured from
the admin web interface.
• HTTP access to the camera can now be disabled by an admin. When this is disabled, HTTPS must be
used to connect to the web interface.
• Added ability for the administrator to disable the camera’s Telnet server through the web interface.
• Support for DNS Service Discovery.
• Initial public REST API.
• Soft DIP in admin web interface to turn off the camera’s LED during standby instead of displaying its
normal standby color.
• Telnet command to allow Streaming Enabled status to be toggled: [streaming ip enable toggle]
To Next Page
Need help?
General
