To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?Do you have a question about the Vaillant ecoFIT pure Series and is the answer not in the manual?
General| Mounting | Wall-mounted |
|---|---|
| Efficiency Rating | A |
| Fuel Type | Natural Gas |
| Warranty | 2 years |
| Model | ecoFIT pure |
| Dimensions | 700mm x 390mm x 295mm |
| Efficiency | 94% |
Defines the intended purpose and prohibited uses of the product.
Specifies the necessary qualifications for performing work on the product.
Provides essential safety information to prevent risks and damage.
Safety instructions for gas leaks, including actions to take.
Safety instructions related to flue gases, including what to do if detected.
Electrical safety precautions before working on the product.
Information on registering the appliance for warranty validation.
Identifies and illustrates the functional components of the system boiler.
Details the various safety devices and their functions.
Describes how the boiler behaves during an electrical supply failure.
Explains the overheat lockout function and how to restart the boiler.
Details the built-in frost protection device and its operation.
Explains the safety feature that stops the boiler if the condensate drain is blocked.
Guidelines for selecting a suitable installation location for the boiler.
Specifies minimum required clearances around the boiler for installation.
Details on the positioning of the air/flue terminal relative to boundaries and openings.
Specifies dimensions for terminal positioning based on installation site.
Provides recommendations for horizontal terminal placement.
Procedures for removing and installing the front casing.
Step-by-step guide for removing the front casing.
Pre-installation checks and component installation advice.
Details on connecting water and gas lines according to standards.
Guidance on connecting the condensate discharge pipe.
Steps for installing and connecting the air/flue pipe.
Procedures for electrical installation.
Provides precautions and steps for carrying out electrical wiring.
Steps for establishing the main power supply connection.
Guide on connecting external controls to the product's electronics.
Procedures for initial start-up using the benchmark checklist.
Procedures for checking and adjusting gas settings.
Steps to check and adjust the gas flow rate.
How to check the gas inlet working pressure.
Procedure to check the CO2 content using a check programme.
Step-by-step guide to adjust the CO2 content.
Guidance on eliminating faults based on error messages.
How to access and clear the fault memory.
Procedures for replacing various defective components.
Lists manufacturer requirements for inspection and maintenance intervals.
Lists and explains various diagnostic codes for the product.
Lists and explains various fault codes and their possible causes.
