Vaillant geoTHERM SERIES User Manual

Installer_manual_OEM_Vaillant_PROTO_3_GB-06/11-Vaillant
- 28 -
• Connecttheheatpumptoanelectricalpanelviaan
independentprotectionsystem(dierentialbreakerwithat
least3mmbetweeneachcontact).Seethetablebelow.
Additionalprotectionmayberequiredduringinstallationto
ensurebuercategoryII.
Thepowersupplycut-odevicesmustallowcomplete
disconnectionofthepowerundertheconditionsrequiredfor
over-voltagecategoryIII.
      
Electricitysupply
V-ph-
Hz
230-1-50
Acceptablevoltagerange V 198/264
Maximumpowerabsorbed kW 2 2.3 2.7 5.1 5.1
Maximumcurrent A 7.2 11 14 23 20
Powerfuse(gL) A
10
Type
B
15
Type
B
15
Type
B
25
Type
D
25
Type
D
Maximumcurrentinglycol
pump
A 2
 
B
A
A
A
C
2
1

 
 
• Removethefasteningscrews(A).
• Slidethefrontpanel(2)downwards(B)andpullittowards
yourself(B)usingthehandle.
• Toclosetheappliance,carryouttheoperationsinreverseorder.
 
e
The low and mains voltage cables must be inserted in
dierent sleeves.
2
1

 
 
• Inserttheelectricalpowercablesinpassages(1)and(2)
providedforthispurpose.
• Makesurethattheelectricalcablesarenotincontactwiththe
compressorandthehotpipes.
• Fixtheelectricalcableswiththeclampsinstalledinsidethe
heatpump.
 

3
2
4
1
 
  
  








INSTALLATION

Vaillant geoTHERM SERIES Specifications

General

Type	Air-to-Water Heat Pump
Cooling Capacity	3.0 - 14.0 kW
Operating Temperature Range (Cooling)	10 - 46 °C
Operating Temperature Range (Heating)	-20°C to 35°C
Coefficient of Performance (COP)	4.0 - 4.8 (Depending on Model)