Need help?Do you have a question about the Vaillant geoTHERM VWS Series and is the answer not in the manual?
General| Power Source | Electricity |
|---|---|
| Refrigerant | R410A |
| Cooling Capacity | 3.5 - 14.0 kW |
| Weight (Outdoor Unit) | 120 kg |
| Power Input Heating | 1.1 - 4.2 kW |
Explains how the heat pump system operates, including the refrigerant cycle.
Crucial safety warnings regarding coolant, electrical shock, and potential damage.
Information about R 407 C coolant, its properties, and safe handling procedures.
Provides detailed diagrams of the heat pump's dimensions and required clearances.
A step-by-step overview of the entire installation process from unpacking to handover.
Details essential preparation steps for the installation site, including boreholes and pipe routing.
Specifies requirements for the central heating installation, including flow temperatures and pipe insulation.
Instructions for positioning, aligning, and securing the heat pump at its installation site.
Instructions for filling and bleeding the heating circuit, including valve settings.
Guidance on mixing and filling the brine fluid for VWS models, including approved media.
Essential safety precautions and guidelines for electrical installation.
Details on how to connect the heat pump to the power supply, including different connection types.
Pre-operation checks and familiarization with the controller interface before starting.
Guide to navigating and understanding the controller's interface and displays.
Steps for performing the initial commissioning, including self-tests and system configuration.
How error messages appear, are stored in memory, and can be displayed.
Information on blocking errors, emergency modes, and sensor faults.
A comprehensive checklist to ensure all points are satisfied before putting the heat pump into service.
Detailed wiring diagram showing electrical connections for VWS heat pumps.
Detailed wiring diagram showing electrical connections for VWW heat pumps.
To Next Page