Vaisala MAWS201 - Figure 40 Wind Sensor Attachment; Figure 41 Upper Tube Attachment

User's Guide _______________________________________________________________________
56 ___________________________________________________________________ M210243en-A
6. Attach the wind sensor adapter to the top of the upper tube.
Tighten with the small hex screw (1). For vane alignment
instructions, see section Aligning Wind Vane on page 73. Guide
the wind sensor cable through the upper tube and connect it to
the sensor. Affix the sensor into its place by tightening the
plastic collar (2).
0201-023
Figure 40 Wind Sensor Attachment
7. Attach the upper tube to the base. Guide the tube into its place
with the notch (1) facing the screw (2). Press the tube all the
way down and tighten the hex screw (2). Take the wind sensor
cable out through the opening (3).
3
9806-007
Figure 41 Upper Tube Attachment
8. Attach the sensor arm supports (2) to the upper base. Tighten the
screw properly with an Allen key (1).