Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600
vc@valcontrols.com • www.valcontrols.com
3 Installation guide
1. Connect all wires and make sure that all is connected correctly according to the hardware
manual/installation drawings.
2. Configure the unit using ValConnect or the display and keyboard
a. Configure the position feedback, through ValConnect
b. Configure the pressure feedback, through ValConnect
3. Auto calibrate the unit by pushing CAL button or using ValConnect.
To Next Page
Loading...
