To Next PageTo Next PageWhat to do if Valcom V-1052C have low volume?
If the volume from your Valcom Speakers is low, here are a few things to check: 1. Make sure that the volume control is turned up. 2. Check the voltage at the speaker assembly while it's in use; it should be between -18 to -24VDC. 3. Use a lineman's test set to verify the proper audio level on the Tip and Ring leads.
How to fix Valcom Speakers when there is no audio?
If you're not getting any audio from your Valcom Speakers, here are a couple of things to check: 1. Ensure that the volume control is turned up by rotating it clockwise. 2. Use a lineman's test set to check for the correct audio level on the Tip and Ring leads, and at the source if necessary.
Why are my Valcom Speakers producing a loud squeal?
If you are experiencing a loud squeal (feedback) from your Valcom Speakers, try the following: * First, turn down the speaker's volume by rotating the control counter-clockwise. * Next, increase the distance between the telephone and the speaker. * If the problem persists in severe areas, consider installing a noise-canceling handset on the telephone. * As an additional measure, you can add a V-9964 Stacking Feedback Eliminator.
Provides the physical size and weight of the V-1052C amplified wall mount speaker.
Details the typical area covered by a single wall speaker.
Illustrates the standard wiring for connecting the V-1052C speaker to a Valcom Page Control.
Warns against connecting directly to 25/70/100 Volt amplifiers and suggests a V-1095.
Provides information on how to get assistance for troubleshooting the V-1052C speaker.
Details the procedure for sending Valcom equipment for repair or return.
Steps to diagnose and resolve issues where no sound is produced by the speaker.
Actions to take when the speaker's audio output volume is too low.
Methods to eliminate or reduce audio feedback or squealing from the speaker.
General
