19
The following screen is displayed after selecting No from the question of using a US Robotics modem or after
selecting Yes, setting the dip switches and pressing OK.
4. Complete the instructions on the screen and click OK. The next screen to be displayed requests selection
of a COM Port. Select the proper COM Port and click OK.
The program then attempts to test the communication line between the PC and the modem. If the connection is
okay, continue to Step 5. If the connection fails, you can Abort the setup, Retry the setup or Ignore the warning.
5. After establishing a successful connection, restore the modem's factory default settings as shown below by
clicking on Yes.
To Next Page
Loading...
