8.2.2 PROGRAM MODIFICATIONS AND SETTINGS
1. Start the selected program by pressing one
of the three available buttons.
2. In running program press SET button
3. Modify parameters with the buttons.
4. Press OK button to confirem the value.
5. Press the BACK button to return to the
previous screen.
6. Press the button to display the running
step.
In program STEPS you can change some of the following parameters
depending which MODE the program uses:
MODE 1 which is based on the temperature *
MODE 2 which is based on the time
MODE 3 which is based on the density.
To Next Page
Loading...
