OWNER’S GUIDE
PAGE 9
Figure 3. Lighting with
a taper
iv) If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.
To turn the fire off
Slide the button up past the high heat position to the “O” position.
Both the main burner and the pilot should go out.
While cooling, the coals may make some crackling noises. This is quite normal.
Lighting with a taper
See figure 3.
In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or
long spill. Insert the taper or spill alongside of the left side wall of the firebox and
operate the slide control as described above.
To Next Page
Loading...
Need help?
General
