Valor Portrait Cast Arch Fronts 539 Series User Manual

1
4001125-17
(539AFBv2, 539AFPv2, 549AFBv2, 549AFPv2, 550CPAv2)
©2020, Miles Industries Ltd.
Overview
The 539 and 550 Cast Arch Fronts are supplied with all
the parts necessary for zero clearance installation of
the 530IN/IP appliances into combustible type framing
without need for additional zero clearance parts.
The 539 and 550 Cast Arch Fronts may be used for insert
applications by discarding the unnessary zero clearance
components.
The 549 Cast Arch Fronts are supplied for insert
applications only and do not include components for
zero clearance applications.
Note : There are two versions of the 530 heater:
• 530IN/IP, for zero clearance applications;
• 530INI/IPI, for insert applications ONLY.
The zero clearance version 530IN/IP may also
be installed in insert applications by using a vent
adapter.
The insert version 530INI/IPI however, may not
be used for zero clearance applications.
Note: This kit must be
installed or serviced by a
qualified installer, service
agency or gas supplier.
These instructions are to be
used in conjunction with the
main installation instructions
for the above listed heater
model.
Cast Arch Fronts 539, 549 & 550 Series
Approved for use with Valor heater models 530 and 530 insert ONLY
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and must be
installed for the protection of children and other at-risk
individuals.
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
INSTALLATION MANUAL
Portrait

Valor Portrait Cast Arch Fronts 539 Series Specifications

General

Category	Indoor Fireplace
Fuel Type	Natural Gas or Propane
Venting	Direct Vent
Warranty	Limited Lifetime Warranty
Ignition Type	Electronic
Dimensions	Varies by model, refer to official documentation
Weight	Varies by model, refer to official documentation

Summary

Installation Manual Introduction and Safety

Danger: Hot Glass Warnings

Critical safety warnings regarding hot glass and child protection from burns.

Zero Clearance Installation Requirements

Hearth and Floor Requirements

Mantel Requirements and Clearances

Guidelines for mantel installation and required clearances for zero clearance.

Installation Steps (Zero Clearance)

Mount Stand-off Spacers

Attaching the stand-off spacers for zero clearance installation with warnings.

Fit Side Spacers and Mounting Brackets

Connecting side spacers to mounting brackets and attaching to the heater body.

Locate Top Insulation Pad

Install Barrier Screen

Insert Application Installation

Install Top Baffle and Air Deflector

Securing the top baffle and air deflector to the appliance case for inserts.

Locate Side Mounting Brackets

Secure Outer Cast Plate

Attaching the outer cast plate to the appliance for insert applications.

Hang Inner Cast Arch and Hearth Fender

Cleaning and Maintenance

Safety Warnings for Cleaning

Important safety precautions before cleaning the fireplace components.

Removing the Front Unit