FITTING THE DECORATIVE FIREFRONT
1. To refit the decorative firefront locate
the two screw heads through the keyhole
slots in the brackets located on top of the
burner. If the screw heads do not project
enough or project too far, the screws can
be adjusted. Lower the casting so that it
rests on the hearth. See figure 18.
2. Fit the lower firefront casting below
the front casting locating it as shown in
figure 19.
Page 15
OWNER GUIDE
Figure 19. Lower Firefront casting location
Figure 18. Firefront casting location
To Next Page
Loading...
