While cooling, the coals may make some
crackling noises. This is quite normal.
If the flames go out while setting the
control, repeat the full lighting procedure.
If the flames repeatedly go out have the
fire serviced.
Please note. When first turned on the
flames will appear predominantly blue. The
coals will take time to warm up. Although
some glow will be seen after approximately
ten minutes, the full visual effect will only be
apparent after a somewhat longer time.
The appliance will operate to its maximum potential if the flue is primed during the
first 20 – 30 minutes of operation. To do this, simply turn the control knob to its
‘HIGH’ setting. This will also burn off any carbon deposits that may have formed
during previous operations.
If operating the appliance for long periods it is beneficial occasionally to change
the settings. This will also help to remove any carbon deposits that may form during
operation.
Lighting with a taper
See figure 3.
In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or
long spill. Insert the taper or spill between the second and third left hand ceramic fuel
effect pieces on the first row. Operate the
control knob as described in the section headed
‘To light the fire’.
Page 8
OWNER GUIDE
Figure 2. Lighting the fire
Figure 3. Lighting with a taper
To Next Page
Loading...
Need help?
General
