Valtra 6000 - Page 1337

1280
Model Code Page
101. Special tools
1. 10. 1999
6000--8750
6101
15. 5. 1996
44.2 Mechanical reverse shu ttle
A
ETV 892 180 Drift for fitting needle bearing/sealing ring inside the reverse shuttle input shaft in transmission 300 and 460.
These parts only on tractors without the quick ---shift gear or the DPS.
ETV 894 200 Drift for fitting needle bearing/sealing ring inside the reverse shuttle input shaft in transmission 650
(8450---8750). These parts only on tractors without the DPS gear.
ETV 892 180
ETV 894 200
44.3 4WD clutch/4WD output shaft
A
ETV 893 260
1
) Socket spanner for 4WD output shaft nut (Gearbox 505---905)
ETV 894 170
2
) Socket spanner for 4WD output s haft nut (new tool)
ETV 891 900
1
) Sleeve for fitting 4WD output shaft sealing ring/bearing (Gearbox 505---905)
B
ETV 890 830
1
) Sleeve for fitting 4WD clutch piston onto the o utput shaft (PTO 505 ---905)
1
) Tr a c t o r s w i t h o u t q u i c k --- s h i f t g e a r o r w i t h 2 --- s t e p q u i c k --- s h i f t g e a r
2
) Tractors with 3 ---step quick ---shift gear Delta Powershift. The nut is t he same as the nut at the front end of t he bevel pinon shaft
on 505 ---905 tractors. For this nut spanner ETV 893 440 is used. Spanner ETV 894 170 can be replaced by welding a sleeve onto
the tool ETV 893 440.
ETV 893 260
ETV 890 830
ETV 891900
ETV 894 170