761
Model Code Page
441. Quick ---shift gear
6100--8400 441 1
15. 5. 1993
8. 11. 1990
Reconditioning quick---shift gear (Op.
no. 441)
1. Removing quick---shift gear
A. Splitting tractor betwee n gearb ox---fuel
tank (cab attached to the rear frame)
Note! Splitting can be done also according to instruction 423
1A. In addition, on E---models the sensor wires must be dis-
connected.
ET 893 480
1. Fit support plates ET 893 480 (2 pcs) for preventing front
axle oscillation (fixing bolts M20x35). Drain transmission oil.
2. Remove all engine hood plates. Disconnect the battery
earth cable. Remove the propeller shaftguard and disconnect
the propeller shaft rear flange joint.
Note! On tractors with Delta Powershift the propeller shaft
rear end has a sleeve joint and it disconnects when trac tor is
split
3. Disconnect the heater hoses from the cab front wall.
4. Disconnect the stop control from the injection pump. De-
tach clutch lever from the clutch adjusting rod or cable
(---659477) or disconnect the release cable front end by work-
ing through the access hole on the frame (659478---)
Note! Measure the distance between the clutch adjuster stop
and the wing nut for easier fitting (---659477).
5. Disconnect the socket and the accelerator pedal cable wire
from the cab front wall (on the RH side).
6. Disconnect the electric cable to the starter motor and dis-
connec t the cab earth lead fro m the cab front wall.
7. Mark the steering valve ho ses for easier fitting and discon-
nect the hoses from the valve. Disconnect the windscreen
washer hose and the cable c onnector.
8. Detach the plastic covers from the cab lower front edge.
Unscrew the cab front fixing bolts and raise the cab front end
about 5 cm.
Note! The lifting rope can be attached to the brake fluid reser-
voir bracket. Support the cab front end with trestles.
9. Disconnect the oil cooler pipes from the servo valve block
on the gearbox LH side.
10. Disconnect the hoses and hose connections from the hy-
draulic lift control valve (on the RH side of the gearbox) for
easier work. Disco nnec t the hoses from the pressure filter.
To Next Page
Loading...
