593
Model
Code Page
18.06.1997 6000---8400 39 1(3)
DPS CONTROL UNIT, fitting instruction
Mounting kit 33464200...................
--- The earlier type control unit no 32861200 (trac-
tors up to no 668102), will be replaced with a
new unit no 33027100 and with an extra wire
loom. The kit incl. also new fastening parts.
In connection with the unit change, the following
functions are added:
--- sound signal for applied hand brake
--- sound signal for head lights
FITTING:
--- Disconnect the battery earth lead.
--- Remove the dash board plate round the instru-
ments.
Push the connector end ”A9” of the wire loom
33031100 into the steering wheel console from
lower part upwards.
--- Part the connector ”A9” halves of the display
unit and connect the wire loom 33031100 corre-
sponding connector between the connector
halves.
--- Release the floor mat in the cab RH side front
part and the lower end protection of the gear
levers.
Remove the earlier control unit (32861200).
Remove the power lift switch panel.
Unscrew the panel housing bottom nut.
Loosen the door seal at the rear mudguard.
--- Draw the wire loom 33031100 together with
other cables along the floor into the lower end of
the lever housing. Bind the cable together with
the other cables.
--- Connect the connector ”A10” (in the cab wire
loom to the loosened control unit) onto the new
wire loom.
--- Draw the new wire loom under the mudguard
upholstery into the power lift switch panel hous-
ing (a hole for wires is ready---made).
--- Fa s t e n p a r t s 29--- 36 onto the switch panel.
Connect connector ”(A10)” to the control unit
circuit card and refit the cover. Fasten other
removed parts.
--- Check the function of the DPS and the sound
signals of the hand brake and head lights:
* Alarm buzzer starts to alarm continuously, if the
engine is stopped and the parking brake is not
applied.
* If the engine is started without releasing the hand
brake, the buzzer alarms brokenly.
* If the head lights are on after the current is switched
off , the buzzer alarms brokenly.
To Next Page
Loading...
