599
Model
No Page
3(4)6000---8400FITTING INSTRUCTION 39.3
SPEEDOMETER AND CLOCK 10.06.1994
14.04.1998
II Setting time
1. Push the function key beside the display until
thetimeisshown.
2. The time is shown from 1 to 12.
3. Push the key about 6 seconds, release it.
4. To make the display time less
:
---Push shortly the key once. By pushing the key
immedia tely the display shows the time which
reduces at every push.
To make the display time greater:
---Push shortly the key once and wait about 6
seconds. By pushing after, the time increases at
every push. Adjust correct time by pushing the
key.
5. After adjustment the colon starts to flash and the
correct value is in the memory. Note that the time
must be in the display before starting the setting.
Neither the direction can be changed during the
adjustment.
III Functional check
1.Pushthetimeintothedisplay.
2. Start driving with gear M1 and at engine revs
1500 RPM.
3.Thespeedvaluemustappearinthedisplay.
Check that the speed reading correspond to the
theoretic driving speed.
4. Push the speedometer key while driving after
which the time must appear in the display. Press
once again the same key after which the speed
reading returns to the display.
5. Stop the tractor and after 8 seconds the speed
reading must be zero.
To Next Page
Loading...
