www.vanco1.com
800.626.6445
11
To Control the Source:
1. Plug the IR Blaster into the
IR TX Port on the Transmitter;
place transmitter in front of the
IR eye of the source
2. Plug the IR Receiver into
the IR RX Port on the Receiver;
place receiver at or near display
To Control the Display:
1. Plug the IR Receiver into the IR
Receiver Port on the Transmitter;
place receiver in position where it
is able to receive remote signals
2. Plug the IR Blaster into the IR
Blaster port on the Receiver; place
transmitter in front of the IR eye
of the display
To Next Page
Loading...
Need help?
General
