Need help?Do you have a question about the Vanderbilt PP500-EM and is the answer not in the manual?
General| Type | Proximity Reader |
|---|---|
| Technology | RFID |
| Frequency | 125 kHz |
| Read Range | Up to 10 cm |
| Communication Interface | Wiegand |
| Housing Material | Polycarbonate |
| IP Rating | IP65 |
| Weight | 120 g |
| Card Technology | EM |
| Compatibility | Vanderbilt controllers |
This document serves as an installation guide with factory settings and short commands.
Read general safety precautions before operating and follow all warnings marked on the device.
Product complies with European Directives. EU declaration of conformity is available from Vanderbilt.
Power supply must conform to CE regulations (SELV) and not exceed 10A.
Use screened cables up to 30m. Connect screen to controller or back plate. Ensure single earth connection.
Specifies reading distances for EM4102 (passive) up to 5cm, Cotag (passive) up to 5cm, and Cotag (active) up to 10cm.
Describes the power-up tone and the BCLINK configuration for reader addressing (Entry/Exit).
Details how to enter, exit programming mode, and the automatic timeout after 60 seconds.
Lists pre-configured interface options (A1-A4) and their functions for different host systems.
Steps for mounting the reader, fastening the back plate, and ensuring earthing for proper installation.
Wiring guide for connecting the PP500 to DC22 or DC12 door controllers using BCLINK.
Wiring guide for connecting the PP500 to a DC800 door controller for stand-alone operation.
Wiring instructions for connecting the PP500 to a Granta 4422 module via Wiegand interface.
Wiring guide for connecting the PP500 to a SiPass Integrated ADD5100 Dual Reader Interface using Wiegand.
To Next Page
