16 PP500 Installation Guide
ENG
DC22 & DC12 connections
This is how to connect to an DC22 or DC12 door
controller. The BCLINK interface is used which is
the factory settings for the PP500.
DC22 & DC12 Signal PP500
11 V+ 1 V+
12 0V 2 0V
13 Com C 3 C (H)
14 Com D 4 D (D0)
DC800 connections
This is how to connect to a DC800 door control-
ler for Stand-alone use. The BCLINK interface is
used which is the factory settings for the PP500.
The jumpers in the DC800 shall be set as below:
J1 = Vin (incoming power).
J4 = BCLINK
DC800 Signal PP500
14 V+ 1 V+
15 0V 2 0V
18 Com C 3 C (H)
19 Com D 4 D (D0)
To Next Page
Loading...
