- 20 -
4.10 Parking Mode (Constant Power Supply Needed)
Parking Mode operates as a sentry function under different situations. To
activate Parking Mode, go to “Record Setup” > “Parking Mode” , press
button and select
the following options: Collision Detection,
Collision Detection + Motion Detection, Motion Detection
, Low Bitrates
Recording,
OFF.
NOTE:
To ensure the camera is able to function in Parking Mode, please keep
it powered with a mobile power bank or hardwire it directly to the car
battery. We do not recommend running the camera continuously for
too long time.
The N4 working environment temperature is 14-122°F (-10°C to 50°C),
we recommend using Collision Detection within this temperature
range, so once the temp is beyond the normal working temp range, it
will auto shut off. If the temperature is high, please take camera off
when you parked your car.
1.
2.
4.10.1 Collision Detection Triggered
When the Collision Detection has been turned on, and no movement
is detected after 5 minutes of recording, then Collision Detection is
activated with a Collision Detection icon at the bottom right corner
of the screen, and the camera automatically to turn off. Full frame
recording will be triggered by the Collision Detection sensor. Once
dash camera detects vehicle impacts or collision, it will auto turn on
and start auto recording; it will stop recording and auto off again
after 5 minutes of inactivity.
The Collision Detection sensitivity is adjustable with 3 settings: Low,
Medium and High. Please go to “Record Setup” > “Parking Mode”>
“Collision Detection” to change it for your need.
To Next Page
Loading...
Need help?
General
