- 21 -
When the Collision Detection has been turned on, and no movement
is detected after 5 minutes of recording, then Collision Detection is
activated with a Collision Detection icon at the bottom right corner
of the screen, and the camera automatically to turn off. Full frame
recording will be triggered by the Collision Detection sensor. Once
dash camera detects vehicle impacts or collision, it will auto turn on
and start auto recording; it will stop recording and auto off again
after 5 minutes of inactivity.
The Collision Detection sensitivity is adjustable with 3 settings: Low,
Medium and High. Please go to “Record Setup” > “Parking Mode”>
4.10.2 Collision Detection + Motion Detection Triggered
When the Collision Detection + Motion Detection has been turned on, this is
represented by an Collision Detection + Motion Detection icon at the bottom
right corner of the screen.
If no movement is detected after 5 minutes of recording, there will be an
orange P icon appears in the center of the screen which means Parking
Mode is activated. Once the Front or inside camera detects movement, 3
cameras will simultaneously start auto recording；they will stop recording
after 30 seconds of inactivity.
The Collision Detection + Motion Detection is adjustable with 3 settings: Low,
Medium and High. Please go to “Record Setup” > “Parking Mode”> “Collision
Detection + Motion Detection” to change it for your need.
01-01-2021
3
1440P+1080P+1080P
“Collision Detection” to change it for your need.
01-01-2021
3
1440P+1080P+1080P
To Next Page
Loading...
Need help?
General
