Vari 400803 - Control Panel Lock

The desk may need to be recalibrated if the screen is not showing the correct height—for instance
the display reads 50.5” but is in fully lowered posion. To do this, press the DOWN buon on the
control panel unl the base reaches its lowest posion. Measure the distance from oor to the
top surface of the desktop. If the number on the LED display does NOT match your measurement,
follow these steps:
Press and hold the DOWN buon unl the LED display reads “RST”. Press and hold the “M”
buon unl the LED displays the ashing height. Use the UP/DOWN buons to change the value
of the starng height so that it matches your measurement. The display will return to “RST” in
about 5 seconds.
Finish the reset process by pressing and holding the DOWN buon again unl the desk lowers a
lile bit more, slightly rises, and stops. Release the buon. The new starng height value is saved
and your desk is now ready to use.
NOTE: The LED display has a +/- 0.1 tolerance.
Recalibrating
1
2 3 4
M
If the legs have no response, your desk may need to be reset. Follow the inial setup instrucons
and ensure all connecons are in the correct locaon and fully plugged in. If the legs are rising
slowly, check the input power connecon to make sure it’s secured correctly. If any errors
connue, please contact Vari.
Troubleshooting and Reset
Press and hold the “M” buon (about 8 seconds) unl the LED display switches to “S-” and then
to “LOC”. Release the buon.
Control Panel Lock
1
2 3 4
M
1
2 3 4
M
Press and hold the “M” buon (about 8 seconds) unl the LED switches from “LOC” to the height
display. Release the buon.
Control Panel Unlock
10