10
3 /
Open both access doors on the back and connect the wiring.
Make sure you note the wiring of the connectors as they can be
connected backwards. The flat ribbon cable will have a purple
line on one side so be sure this matches. The power harness will
only connect one way.
2 /
Connect a lifting device to the 2 outside hanging brackets on the top
of the scoreboard and lift enough to acquire access to the back of the
panels. Cardboard or foam packaging can be used as a pad between
the lift and scoreboard to protect the scoreboard face.
Crossover Ribbon
10 Pin Header
Power Harness
Crossover Ribbon
To Next Page
