VarTech Systems VT190P2 - Input Source, Setup, and OSD Configuration

8
VT190DiamondVue/CrystalVueUser’sGuide150‐180

Main Source : Select the input video signal
VGA 1 / Composite Video / S-Video / VGA 2 / DVI / HD/SD Component
Utilities :
Setup 
Auto Picture Setup
#
 : Auto adjust the image position, phase and size
Auto Color Gain
#
 : Auto Color Calibration (Function in ARGB mode ONLY – See
appendix IV)
Manual Clock
#
: Adjust the image horizontal size
Manual Phase
#
: Fine tune the data sampling position (adjust image
quality)
Auto Source Seek : OFF / ON
ON – Auto source select always enable
OFF – Disable auto source select function
Auto Power : OFF / ON
ON – Enable soft power off function if absence of input signals
OFF – Disable soft power function
Video Standard (SD)** : Auto / NTSC / PAL / SECAM / NTSC 443
Gamma : 1.0 / 1.6 / 2.2
OSD 
H Position : Move the OSD menu image horizontally
V Position : Move the OSD menu image vertically
Timeout (sec) : 1 – 20 : Adjust the OSD menu timeout period in a step of 1
seconds (max 20 seconds)
Language : English / Simplified Chinese : Select OSD menu language display
Transparency : 0 – 100 steps