8 / 10
dISP inversion of the Display
1. Push the UP/DOWN buttons until the display shows dISP.
2. Push ENTER
3. Use the UP/DOWN buttons to choose from dISP and dSIP, in this case dSIP means the
display is inverted and turned 180°
4. Push ENTER to confirm
FhrS Zeigt die Laufzeit des Gerätes an
1. Push the UP/DOWN buttons until the display shows SLNd.
2. Push ENTER
3. Now the display shows the running time of the item.
Ver Software Version auslesen
1. Push the UP/DOWN buttons until the display shows SLNd.
2. Push ENTER
3. Now the display shows the actual software version
5. Master Slave configuration
If you want to daisy chain and control more than one item you can use the Master Slave Mode. To do
so you have to daisy chain your items as you would do when you want to set up a dmx chain. You can
use max 16 items for this mode. The first item in line is the master and the other items will react
according to him. The master item can be set up to the desired program or mode and the others will
follow. The slave items wshould be set up as follows.
1. Push the Menu button as often until you see SLNd in the display. Push Enter to confirm.
2. No choose the desired Slave mode and confirm again with ENTER.
3. The slave item will now react according to the master.
6. Sound to Light
- Set up the sound to light mode to ON as described above.
- Now the item will react according to the sensitivity you set up at the mic.
- This option can be used with the master slave mode as well.
To Next Page
Loading...
