Vax S86-SF-CC - Taking care of your machine; Emptying Water and Detergent Tanks; Removing Cleaning Pads; Storing Your Steamer

Taking care of your machine
To remove the water tank
press both water tank
release buttons, and pull
to remove.
Emptying the water/detergent tanks
Pull the tab on the water
tank to open.
Using your foot, hold the corner
of the microbre cleaning pad
down, lift steamer to peel away.
The microbre pad is machine
washable (Max 40⁰C) allow
to fully dry before use.
Wrap the power cord around the
quick cord release hooks and insert
the plug into the plug storage socket.
Removing cleaning pads Storing your steamer
Max 40°C
Empty any excess water
over the sink.
Rinse water tank with water and
replace water tank tab, push rmly
to close before replacing back onto
the steamer.
Press the release buttons
and pull the detergent
tank to remove.
Emptying the detergent tank
Twist detergent tank
cap anti-clockwise and
lift to remove.
Empty any excess
detergent over the sink.
Rinse detergent tank with water,
replace detergent tank cap and turn
clockwise to tighten. Replace the
detergent tank back onto the steamer.
IMPORTANT: Allow the steamer to fully cool down before performing any maintenance or troubleshooting checks. Don’t leave water
or detergent in the tanks between uses, as this can eect the steamer’s performance, the water/detergent tanks need to be emptied
and rinsed after each use.
IMPORTANT: Don’t use bleach or fabric softener when washing the microbre cleaning pad. Always allow the steamer to fully
cool down before removing the microbre cleaning pad.
Taking care of your machine