Vax S86-SF-CC - Using your machine; Filling water tank; Filling detergent tank

Using your machine
Press the water tank release
buttons and pull the water
tank to remove.
Slide the water tank back into
the machine until it clicks
into place.
Pull the tab on the water tank
cap to open.
Fill the water tank with
260ml of water, replace the
cap and push rmly to close.
Twist the detergent tank
cap anti-clockwise and lift
to remove.
Pour 50ml of Vax detergent
and 150ml of water into the
detergent tank.
Press the release buttons
and pull the detergent
tank to remove.
Filling water tank
Replace the detergent tank
back into the steamer and
push until it clicks into place.
Replace the detergent
tank cap and twist
clockwise to close.
Filling detergent tank
Using your machine
IMPORTANT
• If you don’t want to use detergent on your ooring, turn detergent dial to OFF position.
• Always test on an inconspicuous area of ooring rst before using detergent.
• Don’t over ll the clean water/detergent tanks or exceed the maximum amount required.
• Don’t use the steamer without water in the water tank. Always top up with water in good time.